Back To Back Regulatory Traffic/Road Signs Installation
Hoop Bollards
Lamp Column Internal Installation
Flexi "B" Bollards
Solar Installations
Patents Granted - Full details on Request.
Sign Specifications:
Either Avery 6600T or 3M 4090T Translucent retro-reflective material must be used with See@Nite products. Failure to do so may effect the light output of the sign.
(Retro-reflective sign face by others.)
Patented Encapsulated Electroluminescent Lamp Pre-wired with 3.5m cable for connection to driver
Weatherproof IP66 construction
EMC & LVD compliant
Acrylic Vandal resistant sheet
Operating voltage 50 -150v RMS
Operating temperature -10c To +25c
CE marked
Conforms to BS EN 12899
Designed to conform to BS EN60598 (where applicable)
Class II double insulated construction - No earth connection required Laminated bonded construction onto standard aluminium 11-Gauge back-plate.
Optional Back Plate Materials available
Driver Specifications:
Sealed unit for mounting inside post top (Alternative mounting options available)
Microprocessor controlled
Integral IP66 photocell (set approx 70 lux)
Suitable for EL signs up to 900mm dia. (or equivalent load)
EMC & LVD Compliant
Output cables for connecting to sign and mains
Note : ELV (Extra Low Voltage) driver will be available soon.Either mains connections and then transforms down to 12 volts or direct 12 volts connection.Typical 600 mm sign uses 4 Watts of power using ELV driver.
Note: All standard drivers are supplied to fir 76 mm O/D Sign posts.Drivers to fit other post sizes are avalable to special order at addtional cost.
